Quick add a typical device
Shown in the results only.

Results

-

Estimated cost per year for a combined average load of 0 W.

  • Energy per day -
  • Energy per year -
  • Cost per month -
  • Cost over five years -
  • Every 10 W, per year -
  • Heat output -

Estimates assume a constant average draw for the hours you set. Measure each device at the wall for real numbers.

How to get good numbers

The calculator is only as good as the watts you enter. Spec sheets and power supply ratings describe maximums, not what a machine draws on an ordinary day. A plug-in power meter costs little and settles the question. Measure each device:

  • At idle, which is where a homelab spends most of its life.
  • During a typical workload, such as streaming, backups or a few busy VMs.
  • During heavy jobs, such as scrubs and large transfers, to size your UPS.

Then enter a realistic average. For most labs that is close to the idle figure. The quick-add buttons use typical idle values from our own measurements, but individual machines vary widely, especially used servers with different drives, cards and firmware settings.

How the calculation works

  • Energy per day in kWh equals total watts multiplied by hours per day, divided by 1,000.
  • Energy per year is the daily figure multiplied by 365.
  • Cost is energy multiplied by your price per kWh. Use the total price on your bill, including delivery charges and taxes, divided by the kWh billed.
  • Heat output uses 1 W equals about 3.412 BTU per hour. Every watt your lab draws ends up as heat in the room.

Rule of thumb

Every 10 W that runs around the clock uses about 87.6 kWh a year. When comparing two machines, multiply the difference in idle watts by 8.76 to get the yearly difference in kWh.

What the numbers usually show

Most people are surprised by two things. First, older rack servers can cost more to run over three years than a new mini PC costs to buy; our field note The Real Cost of a Free Server walks through a real example. Second, small devices add up: a switch, two access points, a couple of single-board computers and a modem can quietly reach 50 W between them.

For ways to bring the total down, see Racks, Power and Cooling, and for hardware that idles efficiently, see Choosing Homelab Hardware. To weigh running costs against the subscriptions a server replaces, see Budgeting a Homelab and the Payback Calculator.